Droopy Leaves on a Hot Day. Water...or Not?

Do your plants have droopy leaves on a hot afternoon? 

 

There are two schools of thought.

One school says plants conserve moisture on a hot afternoon by allowing their leaves to sag.

The other school says: don't believe them. Drooping leaves are usually indicative of a lack of water from the root zone. "Large, thin leaves, common in many of ornamental, annual and vegetable species, do not conserve water," writes Washington State University Horticulture Professor Linda Chalker-Scott. "Tomatoes, zucchini and black-eyed Susans...are not water conservers. Chronic wilting of these and others can eventually cause leaf tip and margin necrosis (or tissue death). It also reduces growth, so that your yield of tomatoes, zucchini and black-eyed Susans will be decreased."
She advises applying a layer of mulch around those plants to help conserve water.

Also, check the moisture at the root level before watering.
To determine the amount of water at the root level:

• A day or two after watering, dig down 8 to 10 inches with a trowel or small shovel, near the drip line (outer canopy) of the plant. Doing this in two or three spots would be more helpful.

• At that depth, grab a handful of the soil. Squeeze that handful. If it is muddy and watery, reduce your watering for plants that require regular (but not frequent) irrigation. If it is so dry you cannot form a clod in your hand (it turns to dust instead), increase your watering (for those plants that require moderate amounts of water).

• If you can form a dirt clod in your hand, yet break it apart with a little effort, that is probably the correct soil moisture for your plant.

• Steve Zien, owner of the Citrus Heights-based organic landscaping consulting service, Living Resources, recommends the use of a soil sampling tube to determine the moisture at root level. "Just press the tube down six to eight inches into the soil after you are done watering," says Zien. "When you bring it back up, the open slot along the side of the tube will let you see if the soil at that depth is wet, moist or dry. Adjust your watering time so that the soil sample is moist, not too wet or dry."

• An easier, but more unreliable way to measure the water content of the soil: purchase an inexpensive (under $10) moisture meter, available at most nurseries. Test its accuracy by putting its probe into a glass of water. If the probe does not read "wet", choose another. Expect it to function for only a year or so.

• Battery operated moisture meter probes may set you back a few more dollars, but in my experience - with proper care (clean them after each use, don't leave them outdoors) - they will last many years.

• Extended, infrequent, slowly applied irrigation is the most efficient watering method. Soaker dripline or drip irrigation systems work best. Here in the Central Valley, foothills and Bay Area, run them for 3 to 6 hours at a time, twice a week, in the summer. This is only a guideline to get you started. Adjust that timing to your particular soil type and plants.

• And, don't forget: add more drip emitters and drip lines as the plant grows, especially for trees and shrubs. Make sure to get water to the outer canopy of the plant (and beyond) where the roots travel.

Improper watering is the number one cause of plant failure. Knowing how wet the soil is at the root level can help you keep your plants healthy.

Keep in mind: different plants have different watering needs. Learn those needs, then group plants together with similar watering requirements when designing your landscape. The Sunset Western Garden Book is a good source for that information.

Signs of not enough water at the root level of plants:
Wilted leaves in the morning. Wilted leaves in the afternoon.
Wilted leaves in the evening.
Red-brown margins of leaves.
Premature fall color of leaves.
Growth reduction.
Leaf drop.
Branch dieback.

Signs of too much water (also called aeration deficit) at the root level of plants:
The soil has a foul smell, like rotten eggs.
Soil is a blue-gray color.
Yellowing, wilting and/or dropping of leaves.
Limited new growth.
Small, corky outgrowths on the undersides of leaves.

Be warned, though: sometimes, symptoms of overwatering and underwatering can be the same (such as leaf wilting). And, symptoms of soil water problems may actually be another problem...that was caused by your watering regimen! Root rots, for example, thrive in saturated soils.

Frequent, light watering leads to shallow rooting, increasing the chances of plant problems.

How much water does your lawn need?

Some tips from the UC Integrated Pest Management Website:


• Avoid planting turf species that require frequent watering, such as bluegrass or ryegrass.
• Design your landscape to minimize water runoff onto hard surfaces and into storm drains.
• To reduce runoff, install non-irrigated buffer areas, which include water-efficient plants or permeable features, next to sidewalks or on slopes.
• Aerate heavy or compacted soils, so water can easily move down to reach grass roots.
• Install an irrigation system that you can adjust to properly water areas of your landscape that have different requirements.
• Water only when your lawn needs it.
• Water requirements vary according to turf species, location, and month of the year.
• Most lawns need water when the top 2 inches of soil have dried out.
• Shady and sunny areas and different soil types will have different water requirements.
• Deeper, less frequent watering is best for most lawns. Water only 2 to 3 times a week.
• Make sure your sprinkler system isn’t producing runoff, especially on slopes. If you see runoff, use shorter watering times and repeat the cycle to allow time for the water to move into the soil.
• Water early in the morning when evaporation and wind are minimal.
• Adjust your watering schedule seasonally, and shut off your irrigation system during rainy weather.